Sergal Vasa

Thankyou for your very kind comments! :D ,I removed the stock kit ladders that were straight and incorrect.I made my own from some extra stock that I had hanging around.These proved to be quite the challenge.I know"Geez Walt,they are only ladders"but the ladders are curved.It took alot of eyeballing to get the steps to the proper angle.The two nights later and third set turned out to be the only ones that looked half way decent.Cheers friends Walter.........Hola, Gracias para tus mismo comentarios de la clase
quité las escalas comunes del kit que eran rectas e incorrectas. Hice mis los propios de alguna acción adicional que tenía colgante alrededor. Éstos demostraron ser absolutamente el desafío. Know" I; Geez Walt, son solamente ladders" pero se curvan las escalas. Tomó mucho calcular visualmente para conseguir los pasos al ángulo apropiado. Las dos noches más adelante y el tercer sistema resultaron ser las únicas que miraban la media manera decente. Anima a amigos Walter
 

Archivos adjuntos

  • m_m_Scratch built ladder 1-1.jpg
    m_m_Scratch built ladder 1-1.jpg
    288 KB · Visitas: 4.534
  • m_m_Scratch built ladder 2-1-1.jpg
    m_m_Scratch built ladder 2-1-1.jpg
    280,5 KB · Visitas: 4.533
Hello.Today I tested a sample of what the red paint would look like weathered.The red paint was just too new and bright and did not match the rest of the weathered parts of the ship.I tried using a mixture of acrylic paints but I think that I may have thinned it too much Some spots had a tendency to alligate. I ended up using a mixture of enamel paint 1 part black to two parts light gray thinned down quite abit.I painted it over the red one section at a time letting it set for one minute then wiping it away.Im very pleased with the results.The photo is abit deceiving looking abit shiney.I think this was do to the flash.I may seal it with a light coat of dullcoat.Cheers Walter ...........Probé hoy una muestra de lo que parecería la pintura roja resistido. La pintura roja era apenas demasiado nueva y brillante y no emparejó el resto de las piezas resistidas de la nave. Intenté usar una mezcla de pinturas de acrílico pero pienso que pude haber enrarecidola demasiada algunos puntos tenía una tendencia al alligate. Terminé encima de usar una mezcla de pintura del esmalte 1 porción de negro a dos porciones gris claro enrarecido abajo absolutamente de abit. Lo pinté sobre la una sección roja a la vez que lo dejaba fijar para un minuto entonces que lo limpiaba lejos. Im muy contento con los resultados. La foto es abit que engaña mirando shiney del abit. Pienso que era esto hace al flash. Puedo sellarlo con una capa ligera del dullcoat. Aclamaciones :D :D :D
 

Archivos adjuntos

  • m_Red Paint before weathering-1.jpg
    m_Red Paint before weathering-1.jpg
    270,7 KB · Visitas: 4.533
  • m_m_Wasa weathered red paint 1-1.jpg
    m_m_Wasa weathered red paint 1-1.jpg
    181,5 KB · Visitas: 4.531
  • m_Paint Weathering-1.jpg
    m_Paint Weathering-1.jpg
    291,3 KB · Visitas: 4.534
  • m_Wasa Stern Red paint weathered_edited.jpg
    m_Wasa Stern Red paint weathered_edited.jpg
    266,3 KB · Visitas: 4.533
Hi walter, your Vasa is very nice, i think hat you found a pretty red, and the combination of wood black and red is super

Hola Walter, tu Vasa esta muy bien,creo que has encontrado un rojo bonito, y la combinacion de madera, negro y rojo esta fenomenal.

Cheers
Jesús
 
me gusta el tono de color rojo que tiene tu vasa walter,y el barco esta muy bien
I like the tone of red you have your walter vasa, and the boat is very well
saludos Guillermo :wink:
 
Hello Jesus,papemodel and Guillermo.Many Thanks for your kind comments.Pepemodel,the model is 1/60 scale when complete 118 cm in length.Im going to build my own display case but because of the size,im sure it will be pretty expencive.I have started to add the sculptures around the aft door areas as well as the wreaths for the round cannon ports.I just bought a new computer because my other computer blew up :x .So I lost the photo showing my latest progress :( .I will post some new photos soon.Cheers friends,Walter...........Hola Jesús, papemodel y Guillermo. Muchas gracias para sus comentarios amables. Pepemodel, el modelo es la escala de 1/60 cuando 118 cm completo en la longitud. Im que va a construir mi propia vitrina pero debido al tamaño, im seguro esto será expencive bonito. He comenzado a añadir las esculturas alrededor de las áreas de puerta de popa así como las coronas para los puertos de cañón redondos. Sólo compré una nueva computadora porque mi otra computadora explotó:x .So perdí la foto mostrando a mi último progreso: (.I fijará algunas nuevas fotos pronto. Amigos de aclamaciones, Walter
 
Esta es mi versión del Vasa sobre kit de Corel
305028_396790737041681_1325845859_n.jpg


394264_396790763708345_246135843_n.jpg


418633_396790790375009_1564053803_n.jpg


376751_396790807041674_1362925418_n.jpg


405916_396790917041663_476571084_n.jpg


253070_396790873708334_1443304965_n.jpg
 
Blog con las fotos de mis modelos

http://mimodelismonavalestatico.blogspot.com.es/" onclick="window.open(this.href);return false;
 
Atrás
Arriba